2004-11-08, 12:43
Biegen is einfach: Rohr einschneiden, biegen und wieder zusammenschweißen.. ![[Bild: wink.gif]](https://www.downhill-board.com/images/graemlins/wink.gif)
Ist die Gabel von den Einbaumaßen korrekt gezeichnet? Wenn ja, bitte ich um ein step-file.![[Bild: laugh.gif]](https://www.downhill-board.com/images/graemlins/laugh.gif)
![[Bild: wink.gif]](https://www.downhill-board.com/images/graemlins/wink.gif)
Ist die Gabel von den Einbaumaßen korrekt gezeichnet? Wenn ja, bitte ich um ein step-file.
![[Bild: laugh.gif]](https://www.downhill-board.com/images/graemlins/laugh.gif)